Any colour, built to last.
Electrostatic powder coating over a 7-stage pretreatment — matt, gloss, texture and metallic across the full RAL range. Even coverage into edges and recesses, oven-cured hard.
Any colour, any finish
The full RAL range in matt, satin, gloss, texture and metallic — over a 7-stage pretreatment and oven-cured hard, matched to your sample and repeatable batch to batch.
The coat is only as good as the prep — degrease, phosphate and rinse give the film its adhesion and corrosion life.
Electrostatic wrap plus technique push powder into corners and returns a wet spray would starve or run.
Matched to a RAL, BS or Pantone sample and logged by batch, so a re-order comes back the same colour.
Any colour, by the rack
Racked and run in colour batches so a whole order comes off the same shade — from a single bracket to a full production run. Swipe the gallery.
Design it to coat clean
A few habits give an even, durable finish with no bare spots or fit problems. Tell us the faces that matter and what has to stay bare — we plan the hang and the masking.
Give it a hang point
A hole or tab to hang from — every part rides the line on a hook, and that spot stays bare.
Mind deep recesses
Powder is drawn to edges and starves the bottom of deep, narrow channels (the Faraday effect) — open them up if you can.
Mask what stays bare
Threads, bearing bores and earth points must stay coating-free — flag them and we plug and mask before the booth.
Coating adds thickness
Two coats build 60–120 µm on every face — allow clearance on close-fit holes, pins and mating edges.
What comes off the coating line
Finished parts in every colour and finish — grilles, guards, frames and enclosures, matt to metallic. Click any for full size.
Even, edge-to-edge — electrostatic coverage into corners and returns, no thin spots or runs.
Cured hard — oven-cured to full chemistry, so the finish resists chips, scuffs and weather.
Colour you can re-order — matched to a RAL/BS/Pantone sample and logged, so batch two matches batch one.
Masked & hung to plan — threads and mating faces kept bare; hang points chosen where they won't show.
The whole line
Got parts to finish? Pick a colour.
Send the parts and a RAL — back in a priced quote with finish, masking and lead time confirmed.